🖱️ Click and drag to rotate. Click on the grid to modify it.
Standard 42mm grid, 7mm height units.
A round tube instead of a rectangular box. Slip-On: the lid telescopes down over the base, Split Ratio (above) sets how much of the height is base vs. lid. Split: base and lid meet flush and swing open on a hinge instead - a telescoping lid can't also be hinged, so Hinge Assembly and Create Lip (Structure tab) only work in Split mode. No Cover: a single open tube, no lid at all. Wall Thickness/Tolerance come from the Structure tab.
💡 Evenly-spaced radial walls from the center to the base's inner wall, splitting it into pie-slice compartments.
💡 On the 3D grid (Hidden lid view): Click + drag = move a divider | Ctrl + click + drag = add a divider | Shift + click = delete a divider
Tabs are placed manually, not auto-generated. Turn on "Place Tabs" above, then click a divider wall (parallel to the front wall) to add a tab there, or click an existing tab to remove it. Turn it back off, then click any tab to set its label.
Turn on "Place Sockets", then click any room's floor to open its rows/columns/diameter settings (works on a plain room to create a new socket zone, or an existing one to edit it). Turn it back off to prevent idle clicks from popping the editor - an existing socket room's floor still opens it either way.
Ctrl+click+drag on the 3D grid = add a divider | Shift+click = delete a divider
💡 A rows x columns array of blind round holes for holding drill bits, sockets, or ratchet inserts upright - cut down from the base's own open top, stopping short of the floor. Diameter steps evenly from Min to Max across the grid (left-to-right, top-to-bottom), like a real drill index or socket set.
Drag a row's end handle (the small tab past its last hole) in the 3D grid to stretch that row to a custom width, if the auto-packed layout doesn't fill the space the way you want.
The plaque is inset flush with the wall (same Panel Thick. as decorative panels below) and cleanly replaces whatever's underneath it - no separate "standoff" depth to configure. Click + drag the plaque in this preview to reposition it (snaps to a 2mm grid).